The fault is not in the control unit that records the interface fault. If there are no further test modules in the test plan then no further repair measures are required. These types of faults are consequential faults. Work through all stored faults of the partner control unit according to the test plan.Įspecially faults that affect the vicinity of the partner control unit (e.g. The fault code is entered after starting the control unit after a maximum of 10 seconds. Note: The designations of terminal status or PWF status apply according to the vehicle electrical system of the vehicle. In this case, a fault code should also be stored in the corresponding partner control unit. The fault is logged when the partner control unit (=interface) transmits a substitute value or a value designated as invalid instead of the required information. The control units exchange information via the bus.Īn "interface error" (invalid signal) is stored when urgently required signals are only received in the form of a substitute value or as an "invalid signal".
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |